UV-Curing System U-300 up to 300MM Wafer and Frames

The POWATEC Curing systems are built to cure wafers and frames up to  300mm. The LED generates a wavelength of 365 nm with an optical power output of maximum 270 mW.

Open the cover and put the wafer on the left side conveyor. Push the start button. The wafer moves over the LED unit to the right side. Curing is completed after about 20-30 seconds, yielding a consistent throughput of 130-180 frames/hour. Fully adjustable curing time ranges between 15 seconds and 3 minutes.

Key features:

  • Low cost in Procurement = Lowest total cost of ownership (COO)!
  • No development of harmful ozone
  • Zero warm-up time
  • Long service life of UV-LEDs (10,000 hrs +)
  • Low intensity drop (5% in 10,000 hours)
  • No thermal influence on the film
  • Compact and robust table design
  • Short installation and implementation time
  • Low cost to maintain
  • Conforms to IEC 204-1 safety standards
  • Productivity 130-180 wafer / hr.


  • Nitrogen Shower
  • Support table with storage space, suitable for clean room


Download product catalog UV Curing System U-200 & U-300